PM1000 is a heat cured, clear (amber) phenolic coating which exhibits outstanding properties in the areas of:
- Corrosion Resistance
- Abrasion Resistance
- Chemical Resistance
- Versatility
PM1000 meets the requirements of the U.S. Federal Register, Code of Federal Regulations (CFR) – Title 21 Food and Drugs, Chapter 1, Paragraph 175.300.
PM1000 is applied by spray coating the part, the typical coating thickness is 0.0005″, the range of thickness is .0003″ – .0008″.
The coating retards oxidation of the base material. This coating is not meant to provide impact protection.
The recommended Maximum Operating Temperature of this high performance coating is 392°F (200°C).
PM1000 does not contain any plasticizers. Applications include tank linings, fans, blowers, filter plates, exhaust hoods, magnets, magnet assemblies, pole pieces, rotor assemblies and such.
Typical Functional Performance
| Functional Group |
Test |
Value |
| Pencil Hardness |
|
3H |
| Taber Abrasion |
(CS-10 Wheel, 1 kg. Load, ASTM D-1044, D-51) |
43 mg/1000 Cycles |
| Corrosion Resistance |
Salt Spray, ASTM B-117 (Steel Q-panels, zinc phosphate, .5 mil film thickness, nominal) |
500+ Hours |
The following is a guide showing references to the chemical resistance capabilities of PM1000. Please note that this is simply a guide and more testing would need to be done if you expect any contact between PM1000 and any of the below chemicals.
| Chemical Resistance Guide |
Splash/Spill |
Immersion |
| Acids |
Good |
Fair |
| Solvents |
Excellent |
Excellent |
| Inorganic Salts |
Excellent |
Good |
| Water |
Excellent |
Excellent |
TDS: PM1000 Rev 3 (09/14/2010)