PM1000 is a heat cured, clear (amber) phenolic coating which exhibits outstanding properties in the areas of:

1. Corrosion Resistance
2. Abrasion Resistance
3. Chemical Resistance
4. Versatility

PM1000 meets the requirements of the U.S. Federal Register, Code of Federal Regulations (CFR) - Title 21 Food and Drugs, Chapter 1, Paragraph 175.300.

PM1000 is applied by spray coating the part, the typical coating thickness is 0.0005", the range of thickness is .0003" - .0008". 

The coating retards oxidation of the base material.  This coating is not meant to provide impact protection. 

The recommended Maximum Operating Temperature of this high performance coating is 392°F (200°C).

Typical Functional Performance

Pencil Hardness	3H
Taber Abrasion
(CS-10 Wheel, 1 kg. Load, ASTM D-1044, D-51)	43 mg/1000 Cycles
Corrosion Resistance
Salt Spray, ASTM B-117 (Steel Q-panels, zinc phosphate, .5 mil film thickness, nominal)	500 Hours +

Chemical Resistance Guide	Splash/Spill	Immersion
Acids	Good	Fair
Solvents	Excellent	Excellent
Inorganic Salts	Excellent	Good
Water	Excellent	Excellent

PM1000 does not contain any plasticizers. Applications include tank linings, fans, blowers, filter plates, exhaust hoods, magnets, magnet assemblies, pole pieces, rotor assemblies and such.

TDS: PM1000 Rev 3 (09/14/2010)